Makita BDF460 Manuale Utente

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.Cordless Driver Dril

10• Check the sound of cooling fan, vent on the charger andbattery, which can be sometime clogged with dust.• The cooling system is in order although

11Switch actionCAUTION:• Before inserting the battery cartridge into the tool,always check to see that the switch trigger actuatesproperly and returns

12Speed changeTo change the speed, first switch off the tool and then slidethe speed change lever to the “II” side for high speed or “I”side for low s

13ASSEMBLYCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before carrying out anywork on the tool.Installin

14Adjustable depth rodThe adjustable depth rod is used to drill holes of uniformdepth. Loosen the clamp screw, set to desired position, thentighten th

15• If the tool is operated continuously until the batterycartridge has discharged, allow the tool to rest for 15minutes before proceeding with a fres

16• Always secure small workpieces in a vise or similar hold-down device.• If the tool is operated continuously until the batterycartridge has dischar

17EN0001-1Recycling the BatteryThe only way to dispose of a Makita battery is to recycle it.The law prohibits any other method of disposal.To recycle

Memo18

Memo19

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

Memo20

21FoldCutStampTimbreMakita Canada Inc.1950 Forbes Street,Whitby, OntarioL1N 7B7

22Your answers to the following questions are appreciated.Date Purchased Model No.Serial No.Initial Last NameStreet AddressCity ProvinceAGE:Male Femal

23Factory Service CentresFor the authorized service centre nearest you please refer to the local yellow pages directory under “tools” or con-tact our

Warranty PolicyEvery Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects fromworkmanship

3SAVE THESE INSTRUCTIONSWork Area1.Keep your work area clean and well lit.Cluttered benches and dark areas invite acci-dents.2.Do not operate power to

418.Maintain tools with care. Keep cuttingtools sharp and clean. Properly maintainedtools with sharp cutting edge are less likely tobind and are easie

5SAVE THESE INSTRUCTIONSWARNING:MISUSE or failure to follow the safety rules stated in thisinstruction manual may cause serious personal injury.SYMBOL

6c.That wire size is at least as large asthe one specified in the table below.9.Do not operate charger with damagedcord or plug - replace them immedia

78.Do not charge inside a box or container ofany kind. The battery must be placed in awell ventilated area during charging.SAVE THESE INSTRUCTIONSSYMB

8FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before adjusting orchecking function

95. If you leave the battery cartridge in the charger after thecharging cycle is complete, the charger will switch intoits “trickle charge (maintenan