Makita 6300D Manuale delle Istruzioni

n Dimensions (LxWxH1 Capacities No load speed IRPM) Steel Wood Wood screw High LOW I @@ Net weight Equipped with Electric Brake 13 mm (1/2")

Drilling operation 0 Drilling in wood When drilling in wood, best results are obtained with wood drills equipped with a guide screw. The guide sc

MAINTENANCE CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection o

ACC ESSO R I ES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of

Mar.-12-'90 EN 13 mm (1/2") CORDLESS DRIVER DRILL ~ Model 63000 Note: The switch and other part configurations may differ from country to c

MODEL 630OD 'LLM $&, DESCRIPTION Mar -12-'90 EN AtD DESCRIPTION MACHINE ___ 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 - 1 1 1 1 1 1 1 1.

MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RI

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15.

I M PO RTA N T Length of Cord (Feet) AWG Size of Cord SAFETY 25 50 100 150 18 18 18 16 IN STRU CTI 0 N S 1. SAVE THESE INSTRUCTIONS - This manual

ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when temperature is BELOW 10°C (5OOF) or ABOVE 4OoC

Charging Use the Fast Charger DC1000 to charge the Battery Cartridge 1000. To remove the battery cartridge, push up the slide plate and grasp th

Nominal diameter of wood screw Bit No. 2.1 - 2.7 (3/32" - 1/8") Selecting bit *Phillips bit Use the chart to determine the best size dr

CAUTION : Before inserting the battery cartridge into the tool, always check to see that the trigger switch actuates properly and returns to the &qu

Overload protector The overload protector automatically cuts out to break the circuit and the button pops out, whenever heavy work is pro