Makita 4334 Specifiche

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.ENGLISHCordless Jig

10Plastic base plate (optional accessory)Use the plastic base plate when cutting decorative veneers, plastics, etc. Itprotects sensitive sur

11To at ta c h t he v ac uu m h ea d o n t he t oo l, i ns er t t he h oo ks o f t he va cu um h ea dinto the hole in the base.

12Tilt the base until the desired bevel angle is obtained. The edge of the motorhousing indicates the bevel angle by graduations. Then tighten

13Finishing edgesTo trim edges or make dimensional adjustments, run the blade lightly along thecut edges.Metal cuttingAlways use a suitable coolant (c

143. Rotate the blade installing lever in the (4) direction until it stops. Theclamp will protrude from the blade holder.4. Remove the cla

153. Grasp the clamp with your fingers so that it will not turn, then rotate theblade installing lever in the (7) direction until it stops. The clamp

Makita Corporation Anjo, Aichi, Japan884361D220

2SPECIFICATIONS•Due to our continuing programme of research and development, the specifications herein are subject to changewithout notice. •Note: Spe

3GENERAL SAFETY RULES GEA002-3WARNING:Read all instructions. Failure to follow all instructions listed below may result inelectric shock, fire and/

420. Maintain power tools. Check for misalignment orbinding of moving parts, breakage of parts andany other condition that may affect the power

5IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGEENC004-11. Before using battery cartridge, read all instruc-tions and cautionary markings on

6FUNCTIONAL DESCRIPTIONCAUTION:•Always be sure that the tool is switched off and the battery cartridge isremoved before adjusting or checking function

7Speed adjusting dialThe tool speed can be infinitely adjusted between 500 and 2,800 strokes perminute by turning the adjusting dial. Higher speed is

82. Pull the blade installing lever in the (2) direction until it stops with a littleclick. If you have difficulty pulling it out, try to do so while

9Removal1. Push the blade installing lever in the (1) direction to release it.2. Pull the blade installing lever in the (2) direction until it stops w