Makita PV7001C Manuale Utente

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comE

10Fit the wool bonnet completely over the rubber pad and pullthe string tight. Tie a bow knot and tuck the knot and anyloose strings between the wool

11Polishing operation by wool bonnetCAUTION:• Always wear safety glasses or a face shield duringoperation.Hold the tool firmly. Turn the tool on and t

12Use a screwdriver to remove the brush holder caps. Take outthe worn carbon brushes, insert the new ones and securethe brush holder caps.To maintain

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSALABAMA2365 Pelham ParkwayPelham, AL 35124 (205) 620-1791ARIZONA3707 E. Bro

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

35. Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

5An adapter Fig. “B” and “C” is available for connecting Fig. “A” type plugs to two-prongreceptacles. The green-colored rigid ear, lug, etc., extendin

69. Do not leave the tool running. Operate thetool only when hand-held.10. Do not touch the workpiece immediatelyafter operation; it may be extremely

7FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

8• Electronic constant speed controlPossible to get fine finish, because the rotating speed iskept constantly even under the loaded condition.• Soft s

9Installing or removing backing padHold the spindle with the wrench so that it cannot revolve.Then screw the pad onto the spindle all the way. (The pa