Makita LS0714FL Manuale delle Istruzioni

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION IMPORTANT: Read Before Using. Slide Compound Saw LS0714 LS0714F LS0714FL LS07

10 • LASER RADIATION, DO NOT STARE INTO THE BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS, CLASS 2M LASER PRODUCT. To t ur n o n th e las

11 1234 012586 Press the shaft lock to lock the spindle and use the hex wrench to loosen the hex socket bolt clockwise. Then remove the hex s

12 123 006792 12 006794 Securing workpiece WARNING: • It is extremely important to always secure the workpiece properly and tightly with th

13 The maximum width of the workpiece which can be secured by the horizontal vise is 120 mm. CAUTION: • Grip the workpiece only when the

14 2. Slide (push) cutting (cutting wide workpieces) 21 005525 Loosen two clamp screws which secure the slide poles counterclockwise so that

15 Miter angleLeft and Right 45 Right 50 Right 55 Right 57 Bevel angleLeft 0 - 45 Left 0 - 40 Left 0 - 30 Left 0 - 25 006393 When performing comp

16 Molding position in Fig. AMolding edge against guide fence(1)For outside cornerFor inside cornerFinished piece(2)(3)(4)Table (B)Finished piece will

17 10. Groove cutting 1 001563 A dado type cut can be made by proceeding as follows: Adjust the lower limit position of the blade using the

18 side of the blade with the face of the guide fence using a triangular rule, try-square, etc. Then securely tighten the hex socket bol

19 Adjusting the position of laser line For model LS0714FL, LS0714L 123 005701 12 005702 WARNING: • As the tool is plugged when adjusting the posit

2 ENGLISH (Original instructions) SPECIFICATIONS Model LS0714/ LS0714F/ LS0714FL/LS0714L Blade diameter 190 mm Blade body thickness 1.3 mm - 2.0 mm

20 Replacing fluorescent tube For model LS0714F, LS0714FL only 123415 002028 CAUTION: • Always be sure that the tool is switched off and un

21 clean according to the directions in the previously covered section titled "Blade guard". Lubricate the sliding portions with machine oil

22

23

24 Makita CorporationAnjo, Aichi, Japanwww.makita.com 884547H226

3 ENE006-1 Intended use The tool is intended for accurate straight and miter cutting in wood. With appropriate saw blades, aluminum can also b

4 4. Keep children away. Do not let visitors touch the tool or extension cord. All visitors should be kept away from work area. 5. Store idle tools.

5 6. Turn off tool and wait for saw blade to stop before moving workpiece or changing settings. 7. Unplug tool before changing blade or

6 INSTALLATION Bench mounting When the tool is shipped, the handle is locked in the lowered position by the stopper pin. Release the stopper

7 immediately. Check to assure spring loaded return action of guards. NEVER USE THE TOOL IF THE BLADE GUARDS OR SPRING ARE DAMAGED, FAULT

8 With the tool unplugged, rotate the blade by hand while holding the handle all the way down to be sure that the blade does not contact any part

9 so that it is slightly above the level. Secure the lever with the screw firmly. Switch action CAUTION: • Before plugging in the tool, always